106973-37-9

106910-76-3

79-04-9

106973-37-9

General procedure: N-benzyl-L-serine (1.0 eq.) and tetrahydrofuran (THF, 6.1 vol.) were added to the reactor. The resulting solution was cooled to 0-5 °C and a pre-cooled aqueous solution of potassium carbonate (3.0 eq.) (6.1 vol., 0-5 °C) was added. Subsequently, chloroacetyl chloride (1.4 eq.) was slowly added through the addition funnel while strictly controlling the internal temperature below 5 °C. The biphasic reaction mixture was aged at 0-5 °C with stirring for about 30 min. After aging, samples were taken for HPLC analysis. If N-benzyl-L-serine residue >6 area percent is detected, chloroacetyl chloride is added additionally. Once the reaction completeness specification was satisfied, 50 wt% sodium hydroxide solution was slowly added, maintaining the internal temperature between 5-10°C until pH stabilization >13.5. The reaction was considered complete when HPLC analysis showed total intermediates <1 area percentage. The reaction mixture was warmed up to 25°C, heptane (2.03 v/v) was added, stirred rapidly for 10 minutes and left to stratify. The upper organic phase was discarded and the aqueous phase was treated again with heptane (3.04 v/v), stirred rapidly for 10 min and left to stratify, the upper organic phase was discarded. The aqueous phase was cooled to -5-0 °C and 37 wt% hydrochloric acid was slowly added, controlling the batch temperature <10 °C until pH <2. The resulting slurry was kept at -10-0 °C for at least 4 h. The slurry was then filtered through a Whatman 1 filter. The slurry was filtered through Whatman 1 filter paper or equivalent and the filter cake was washed with pre-cooled (3-7°C) water (2 x 4.57 v/v). The wet filter cake was dried under vacuum at 40-45 °C to give 1.475 kg (84.9% yield, uncorrected) of (S)-4-benzyl-5-oxo-3-morpholinecarboxylic acid.HPLC analytical conditions: retention time 1.82 min (YMC S5 ODS column, 4.6 × 50 mm, gradient elution from 10-90% aqueous methanol containing 0.2% phosphoric acid, flow rate 4 mL /min, detection wavelength 220 nm); chiral HPLC analysis conditions: retention time 7.94 min, ee value 100% (Chiralcel OJ-R column, 150 × 4.6 mm, 5 μm, eluent: methanol: 0.2% phosphoric acid aqueous solution [50:50], flow rate 1 mL/min, detection wavelength 210 nm).